The Icom IC-7200 is a robustly built amateur transceiver providing coverage of HF amateur bands plus 6 meters. Power is 100 watts. Features include easy-to-use controls, DSP filtering with 51 passband widths, digital twin passband tuning, manual notch filter, keypad entry, dual VFOs, large display, voice synthesizer, 201 memories, 20 dB attenuator, preamp, 6 kHz roofing filter, RIT, scanning, 1 Hz step tuning and more! The excellent general coverage receiver tunes from 30 kHz to 60 MHz. The meter displays Power/SWR/ALC. Power is 2 to 100 watts (40 watts AM).
Although the IC-7200 is not waterproof, extra design steps have been applied to the front panel buttons and knobs. This provides a measure of protection against water intrusion. There is even a USB port on the rear panel! This radio comes with an HM-36 hand mic, OPC-1457 DC power cord and spare fuses.
IC-7200 Specifications | General |
- Frequency Range:
- RX 0.030-29.999999 MHz (guaranteed range: 0.5-29.999999 MHz)
- TX 1.800-1.999999 MHz, 3.500-3.999999 MHz (varies with version)
- 5.3305, 5.3465, 5.3665, 5.3715, 5.4035 *2
- 7.000-7.300000 MHz, 10.100-10.150000 MHz
- 14.000-14.350000 MHz, 18.068-18.168000 MHz
- 21.000-21.450000 MHz, 24.890-24.990000 MHz
- 28.000-29.700000 MHz, 50.000-54.000000 MHz
- Mode: USB, LSB, CW, RTTY (FSK), AM
- No. of memory channels: 201 (199 regular, 2 scan edges)
- Frequency resolution: 1 Hz
- Frequency stability: Less than ±0.5 ppm.
- Power supply requirement: 13.8 V DC ±15% (negative ground)
- Current drain (at 13.8 V DC):
- Receive: stand-by 1.3 A ; max audio 2.0 A
- Transmit: max. power 22.0 A
- Usable temperature range: -10°C to +60°C (+14F to+140F)
- Antenna connector: SO-239 (50 ohm)
- Dimensions: 240mm (W) x 95mm (H) x 239mm (D)
- (projections not included) 9 7/16in (W) x 3 3/4in (H) x 11 1/16in (D)
- Weight: 5.5 kg; 12.1 lb
- ACC connector: 13-pin
- REMOTE connector: 2-conductor 3.5 (d) mm; (1/8″)
|
| Transmitter |
- Modulation system:
- SSB: Digital PSN modulation
- AM: digital low power modulation
- Output power:
- SSB, CW, RTTY: 2-100W
- AM: 1-40W
- Spurious emissions: Less than -50 dB below peak output power
- spurious freq.; below 30 MHz: -50dB, above 30 MHz: -63dB
- Carrier suppression: More than 50 dB
- Unwanted sideband: More than 50 dB
- Microphone connector: 8-pin connector (600 ohm)
- KEY connector: 3 conductor 6.5 (d) mm (1/4″)
- SEND connector: Phono (RCA)
- ALC connector: Phono (RCA)
|
| Receiver |
- Receiver system: Triple-conversion superheterodyne
- Sensitivity: (10 dB S/N)
- SSB, CW, RTTY: 0.16 µV (1.8-29.999999 MHz)
- AM: 13 µV (0.5-1.799999 MHz)
- AM: 2 µV (1.8-29.999999 MHz)
- SQL sensitivity: Less than 5.6 µV (SSB)
- Selectivity:
- SSB, CW, RTTY: More than 2.4 kHz/-6 dB
- Less than 3.6 kHz/-60 dB
- AM: More than 6.0 kHz/-6 dB
- Less than 16 kHz/-60 dB
- Spurious and image rejection ratio: More than 70 dB (1.8-29.999999 MHz)
- Audio output power: More than 2.0 W at 10% distortion with at 8 ohm load (at 13.8 V DC)
- RIT variable range: ±9.9 kHz
- PHONES connector: 3-conductor 6.5 (d) mm (1/4″)
- EXT SP connector: 2-conductor 3.5 (d) mm (1/8″) 8 ohms
- Specifications are subject to change without notice or obligation.
|
